Prior Information; Field Of Application; Liability; Installation - SOMFY PERGOLA 50 io RGS Anleitung

PERGOLA 60 io RGS PERGOLA 50 io RGS

1.PRIOR INFORMATION

1.1.Field of application

The Pergola 50, Pergola 60 drives are designed to drive all types of Pergola awnings, except Pergola awnings with tiltable
slats.
The Pergola 50, Pergola 60 drives are designed to motorise all types of:
▪ Outdoor awning with or without cassette. All shearing zones shall be protected or inaccessible e.g. at a height ≥
2.50 m from the ground or any other access level. There is no shearing risk with the front rail when e.g. the front rail
moves solely by gravity with a mass of less than 15 kg or it is pushed with force less than 150 N.

1.2.Liability

Before installing and using the drive, please read these instructions carefully.
In addition to the instructions provided in this guide, please also comply with the instructions provided in the attached Safety
instructions document.
The drive must be installed by a home motorisation and automation professional, in accordance with Somfy's
instructions and the applicable regulations in the country of installation.
Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to comply
with the instructions given in this guide and in the attached Safety instructions document, absolves Somfy of any liability and
invalidates the warranty.
After installing the drive, the installer must inform his customers of the operating and maintenance conditions for the drive
and must provide them with the operating and maintenance instructions, and the attached Safety instructions document.
Any After-Sales Service operation on the drive must be performed by a home motorisation and automation professional.
Never begin installing without first checking the compatibility of this product with the associated equipment and
accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy representative
or visit the website www.somfy.com.

2.INSTALLATION

WARNING
• These instructions are mandatory for the home motorisation and automation professional installing the drive.
• Comply with current standards and legislation in the country of installation.
CAUTION
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.

2.1.Assembly

2.1.1.Preparing the drive
CAUTION
PERGOLA 50 io RGS : interior diameter of the tube has to be Ø47 mm or greater.
PERGOLA 60 io RGS : interior diameter of the tube has to be Ø60 mm or greater.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
EN
3