Pre-Programming The Control Point; Checking The Direction Of Rotation; Setting The End Limits - SOMFY PERGOLA 50 io RGS Anleitung

EN
▪ Reaction 2:
◦ The motorised product does not move up and down briefly upon power-up and does not react when the buttons
on the control point are pressed.
◦ The end limits have not been set and no control point is programmed.
See section Pre-programming the control point [} 6]
▪ Reaction 3:
◦ The motorised product does not move up and down briefly upon power-up but reacts when the buttons on the
control point are pressed.
◦ The set-up procedure is complete.
To modify the advanced settings, see section Setting advanced functions [} 9]
Follow the following steps for set-up:
1] Preprogramming of the Somfy io-homecontrol® local control point Pre-programming the control point [} 6]
2] Checking the rotation direction Checking the direction of rotation [} 6]
3] Setting the end limits Setting the end limits [} 6]
4] Setting advanced functions Setting advanced functions [} 9]
5] Programming of the Somfy io-homecontrol® local control point Programming the first local io-homecontrol
point [} 10]

3.1.Pre-programming the control point

1] Switch on the power supply.
2] Simultaneously press the Up and Down button: The motorised product
briefly moves up and down.
g This control point is now preprogrammed in the drive.
NOTICE
Preprogramming is lost if power to the drive is switched off before the control
point is registered.

3.2.Checking the direction of rotation

Press the Up button on the control:
▪ If the motorised product rises (a), the direction of rotation is correct.
▪ If the motorised product lowers (b), the direction of rotation is not correct:
◦ Press and hold the My button until the motorised product moves up and
down: the rotation direction has now been modified.

3.3.Setting the end limits

NOTICE
• The end limits can be set in any order.
• The procedure used to set the end limits depends on the equipment of the motorised product (see table below).
• Pressing and holding the Up or Down buttons causes the motorised product to raise or lower continuously.
• Pressing the Up or Down buttons briefly causes the motorised product to raise or lower briefly.
6
PERGOLA 50 io RGS
1]
a
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
PERGOLA 60 io RGS
2]
b