Electrical Connections - Elica CT35 PRO Anleitung Zur Installation, Inbetriebnahme Und Wartung

Push the appliance towards the bottom of the
cabinet in order to make the frame of the ap-
pliance perfectly adhere to the cabinet.
Restore the liquid waste tray and the grease
filters.
Locking of the valve
Warning!
Before connecting the air outlet flexible pipe to
the motor, make sure that the non-return valve,
placed on the air outlet of the motor, is free to
rotate.
Connect the flange of the hood to the exhaust
hole through a suitable duct. Make the electri-
cal connection through the power cable.
REAR AIR OUTLET
The products can be installed with the air out-
let of the motor towards the back side of the
product. If you want to use this option, you
need to remove the motor support removing
the screws (fig. 6), pull out and rotate the sup-
port, position it in its seat keeping the air out-
let towards the rear side of the product (fig. 7).
Fix it with the screws previously removed.
In case of external motor, connect the power
cable of the motor to the terminal board in the
black plastic box, identified through the con-
nection label.

ELECTRICAL CONNECTIONS

If the unit is supplied with power cable with no
plug, please refer to the schema below.
POWER SUPPLY SHOWN IN THE RATING LABEL
3X0.75mm2
WORKING
Push button
L: Light switch on/off
0/1: Motor switch on (1st speed)/off
2: Motor switch 2nd speed
3: Motor switch 3rd speed
4: Motor switch 4th speed
T: 10-minutes timer
When the 4 speed of the motor is set, the rela-
th
ting LED flashes.
After 5 minutes the motor goes back to the 3
speed.
By pushing the T button (timer), 10 minutes after
setting it, the range hood is switched off.
The function is highlighted by the led flashing ac-
cording to the set speed. Press again the T but-
ton to disactivate this function.
The product automatically turns off after 4 hours
of uninterrupted working, from the last function
selected.
After 30 hours working, the push button indicates
the saturation of filter by lighting all buttons,for
about 30 seconds.
Press the timer button (T) to reset, while signa-
ling.
8
rd