Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SIEMENS
release device into the desired position. Press the release
device back into its guiding.
Commissioning
NOTE
Field wires of control circuits shall be separated from
other circuits with respect to the end use
requirements.
NOTE
For electric communication busses, for example
RS485, connect the grounding of all devices that are
connected to the bus to the same grounding
potential.
•
Before commissioning the device, leave it in the final
operating room for at least 2 hours. This allows it to reach
room temperature and to prevent dampness and
condensation.
•
Check that the operational data match the rated data on the
label and the technical data of the device. This applies in
particular to the supply voltage and to the maximum values of
alternating current and alternating voltage.
For device-specific settings, observe the notes in the device
•
manual.
•
Switch on the connected peripheral devices and the supply
voltage of the device at the respective isolating device.
Cleaning
•
Switch off the device.
Wipe the device with a clean, dry and soft cloth. Do not use
•
solvents.
Repacking a Device
If you store devices after incoming inspection, pack them in
•
suitable storage packaging.
If devices are to be transported, pack them in transport
•
packing.
•
Put the accessories supplied in the packing with the device.
For any questions concerning your system, please contact
•
your Siemens representative. The Siemens Customer Support
Center provides around-the-clock support.
Tel.: +49 (1805) 24-7000
Fax.: +49 (1805) 24-2471
Internet:
http://siprotec.de
Contact:
https://new.siemens.com/global/en/products/energy/
energy-automation-and-smart-grid.html
SIPROTEC Accessories – Product Information
C53000-X1199-C588-1, 02.2023
7XV5662-0AC02, 7XV5662-0AC03, 7XV5662-0AA00, 7XV5662-0AD0x
SIPROTEC Accessories
Product Information
8
Werbung
Inhaltsverzeichnis
