Checking The Batteries; Replacing The Fuse - VOLTCRAFT 2633261 Bedienungsanleitung

Neveroperatethemeasuringdevicewhenitisopen.
 !RISKOFDEATH!
 Rechargeablebatteriesmustnotbeused!
  D onotleaveflatbatteriesinthedevice.Evenbatteriesprotectedagainstleakingcancorrodeand
thusreleasechemicalswhicharedetrimentaltoyourhealthordestroythedevice.
Do not leave batteries lying around carelessly. They could be swallowed by children or pets. If swal-
lowed,consultadoctorimmediately.
  R emovethebatteriesifthedeviceisnotusedforalongerperiodoftimetopreventleaking.
  L eakyordamagedbatteriesmaycausecausticburnsiftheycomeintocontactwithskin.Therefore,
you should use suitable protective gloves.
  M akesurethatbatteriesarenotshort-circuited.Donotthrowbatteriesintofire.
  A lwaysreplaceallbatteriesatthesametime.Mixingfullychargedbatteriesandhalf-fullbatteries
reducesbatterylife.Alwaysusebatteriesofthesametypeandmanufacturerinasetofbatteries.
Batteriescanbedamagedbyequalizingcurrentsandmayleak.
 Batteriesmustnotberechargedordismantled.Thereisdangerofexplosion.
You can order suitable alkaline batteries stating the following order no.:
Item no. 652506 (please order six pcs).
Only use alkaline batteries. They are powerful and long-lasting.
d) Checkingthebatteries
The insulation tester ET-100 allows you to check the battery voltage anytime. Switch the measuring device to the "600
V~" measuring range. After about 3 seconds, the small display at the bottom right shows the current battery voltage.
At a voltage of <7.5 V the battery replacement symbol starts flashing automatically.
e) Replacing the fuse
The low-voltage "400 Ω" measuring range is secured with a quick-break fuse. If measuring in this range is no longer
possible, you have to replace the fuse.
Proceedasfollowstoreplacethefuse:
- Disconnect all measuring lines from the device and switch it off.
- Open the battery compartment as described in chapter "Inserting and replacing the batteries".
- The fuse is accessible.
- Replace the defective fuse with a new fuse of the same type and nominal voltage. The fuse has the following
characteristics: F 500 mA/1000 V, size 6.3 x 30 mm, ceramic.
- Properly close the housing again in reverse order.
Usingrepairedfusesorbridgingthefuseholderisnotadmissibleforsafetyreasons.Thiscancause
fireorelectricarcexplosions.Neveroperatethemeasuringdevicewhenitisopen.
38