Horizon Hobby HobbyZone Float Set Bedienungsanleitung Seite 3

Length 23.4" (595mm)
Each Float: 3.5" (90mm)
Width
Assembled Float Set: 14.8" (378mm)
Floats Only: 4.76oz (135g)
Weight
Wire Struts: 1.57oz (44.4g)
Hardware: 0.35oz (10g)
Assemble the Float Set
1. Determine left and right floats and front and rear landing
gear struts. There is a notch on the inside of the floats to
make room for the landing gear struts and spreaders, as
shown in the diagram.
2. The spreaders should be installed on the inner mounting
locations, and the landing gear struts should be located
in the outer front and aft mounting locations.
3. Insert the landing gear struts and spreaders into the
mounting brackets. There are flat spots at the mounting
points on the struts and spreaders. Ensure the wires
are located so the securing screws will engage the flat
spots.
Float Set
Specifications
EN
3