Configuring The Network - Velleman CAMIP23 Bedienungsanleitung

8.4

Configuring the Network

1. Connect your mobile device to the wireless router that has the camera connected.
2. Open the EagleEyes app and click the "+" button to add a new device.
3. Select "Local Network Search" to search for the camera.
4. Select the camera from the list. The settings page appears.
5. In the settings page, switch from "DHCP" to "Static".
6. Change the port number of the camera as needed. The default port number is 88. If port number 88
is blocked, you can change it to any value from 1 to 9999 (for example 9890).
7. Write down the IP address and the port number of the camera. You will need them later.
(In the sample screens below [A], the IP address is 192.168.2.197 and the port number is 88.)
8. Press "Apply" to confirm your settings.
9. Wait until "Status" [B] indicates "Done" or "Fail".
If the status shows "Done", the device page appears again. Proceed with the next step.
o
If the status shows "Fail", press the
o
popup window, select "DDNS". The device page appears again. Proceed with the next step.
10. In "Title" [C], enter a meaningful name for your camera connection and press "Save" to confirm.
A
V. 01 – 06/05/2015
CAMIP23
2. Connect your mobile device to the wireless
router that has the camera connected.
3. Go to Settings > WiFi.
4. Press the ">" button to see the details of
the selected wireless network.
The IP address is visible next to "Router".
(In the sample screen, the IP address is
192.168.2.1)
The device will show a list of devices on the
network. The displayed IP address is the address
that your router assigned to your camera.
If the IPCAM camera is not in the list, make sure
the LAN status indicator
(not blinking). Reset [13] the camera if necessary.
Wait for 3 minutes and then use "Local Network
Search" again.
button on the top right side of your device. In the
B
7
on the camera is on
C
©Velleman nv