Forch F-Smart 12/24 V 25 A Bedienungsanleitung Seite 38

Battery Charging Device F-Smart 12 / 24 V 25 A
EN EN
Safety information
Please read through the safety information carefully before connecting your device to the
mains and operating it as it contains important safety and operating instructions.
Always include these operating instructions when passing on the device to third parties.
WARNING! Failure to do so may result in an electric shock, fire, and/or injury!
Please retain all safety information as well as any other important information.
■
Before connecting the device to the mains, make sure that the mains voltage and current
■
type match the information on the type plate of the device.
WARNING! To prevent electric shocks, do not immerse the device, mains cable, or
mains plug in water or any other liquid. Danger of short circuit!
ATTENTION! This device is not a children's toy! Please keep away from children and
supervise them at all times.
Disconnect the mains plug:
when the device is not in use,
■
before relocating/transporting the device,
■
before cleaning the device.
■
Always pull on the mains plug, never the cable.
■
CAUTION! Do not use the device near explosive/flammable locations, gas or electric
heaters, naked flames, candles or other sources of heat.
Never use a faulty device or a device with faulty cables, charging devices and plugs.
■
Stop using the faulty device and have it checked by Service. Do not open the device!
Note the following points before using the device:
Only use the device in dry rooms.
■
WARNING! The device and mains cable/plug must not come into contact with water or
liquids. Risk of electric shock! Maintain a minimum distance of 3 m from swimming pools,
bathtubs, showers, sinks, etc.
Do not touch the device with damp/wet hands.
■
Place the device on a stable, horizontal surface to prevent engine vibrations, for example,
■
from causing it to fall over.
If the device is damaged in any way, especially the cable, plug or housing, and can no
■
longer operate safely as a result, the power supply line must be disconnected immediate-
ly and the device must be switched off and secured to prevent it from being used again!