Bestway HYDRIUM 561CU Gebrauchsanweisung Seite 4

• Bestway will not be responsible for damage caused to the pool due to mishandling or failure to follow these instructions.
• We strongly suggest to open the package and to assemble the pool when the environment temperature is above 15
degrees; the PVC material of the liner will become more flexible and easier to assemble.
• Before connecting valve to the pool, fill the pool leaving 5 - 6 cm of space between the position of the connection valve
and water surface.
• Never permanently install the connection valve before the water is within a few centimeters of them because the liner has
to be properly taut from the pressure of the water.
• Be careful of any splinters or sharp edges when cutting the pool.
• Cutting more liner than necessary will damage and void the pool liner, so please trim with extra care.
FILLING POOL WITH WATER
• Do not leave pool unattended while filling with water.
• Fill the pool with water after all assembly steps are completed and until the water reaches 15 cm / 6" from to the top rail,
which corresponds to 90% of the full capacity.
• Do not overfill as this could cause the pool to collapse. In case of heavy rainfall, we strongly recommend to reduce the
water level to keep 90% of full capacity, to avoid overflowing of water.
• When the pool is completely filled, check that the distance between the water surface and the top of the rails is the same
all around; in case it is different, it means that the floor is not level so we strongly recommend to draining the water and
leveling the ground again.
• Keeping the pool full of water on uneven ground can cause burst of welding points and/or pool collapse, causing serious
personal injury and/or damage to property.
MAINTENANCE
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
WATER
• Keeping your pool water clean and chemically balanced is necessary. Simply cleaning the filter cartridge is not enough
for proper maintenance, we recommend you use pool chemicals to maintain water chemistry and chlorine or bromine
tablets (do not use granules) with the chemical dispenser.
• Water quality will be directly related to frequency of use, number of users and overall maintenance of the pool. The water
should be changed every 3 days if there is no chemical treatment being performed with the water. It is highly
recommended to use tap water for filling to minimize the influence of unwanted content, such as minerals.
• We recommend to take a shower before using your pool, as cosmetic products, lotions, and other residues on the skin
can quickly degrade water quality. To use the chemical dispenser, follow the instructions in the leaflet.
• If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
• Skim pool regularly to avoid settled dirt.
• Locate a bucket of water next to pool to clean users' feet before entering pool.
• The chemical maintenance must be performed with Chemconnect or chemical floater; don't throw chemical products
directly in the water, the chemical will deposit on the bottom and damage the material and discolor the PVC.
• Your purchased pool set may not include any of those dispensers; in this case you can purchase it by visiting our website
www.bestwaycorp.com or at the nearest pool dealer.
Chemical Tablets (Not Included):
• Remove the chemical dispenser from pool when the pool is in use.
• After performing chemical maintenance and before using the pool, use a test kit (not included) to test the water's
chemical balance. We recommend maintaining your water's chemical balance as follows:
Parameters
Water clarity
Colour of the water
Turbidity in FNU/NTU
Nitrate concentration above that of fill water in mg/l
Total organic carbon (TOC) in mg/l
Redox potential against Ag/AgCI 3,5 m KCl in mV
pH value
Free active chlorine (without cyanuric acid) in mg/l
Free chlorine used in combination with cyanuric acid in mg/l
Cyanuric acid in mg/l
Combined chlorine in mg/l
Values
clear view of the pool bottom
no colour should be observed
max. 1,5 (preferably less than 0,5)
max. 20
max. 4,0
min. 650
6,8 to 7,6
0,3 to 1,5
1,0 to 3,0
max. 100
max. 0,5 (preferably close to 0,0 mg/l)
4