Parkside Performance PWSAP 40-Li A1 Originalbetriebsanleitung Seite 74

c) Do not use any accessories that have not
been specifically provided or recommended
by the manufacturer for this power tool. Just
because you can attach the accessories to your
power tool does not guarantee they are safe to
use.
d) The maximum permissible speed of the acces-
sory tool being used must be at least as high
as the maximum speed specified for the
power tool. Accessories that rotate faster than
the permissible rate can break and throw pieces
into the air.
e) The external diameter and thickness of the
accessory tool being used must comply with
the dimensions of your power tool. Incorrectly
dimensioned accessory tools cannot be suffi-
ciently shielded or controlled.
f) Accessory tools with a thread insert must
match the thread of the grinding spindle
exactly. For accessory tools that are mounted
using a flange, the diameter of the hole on
the attachment tool must correspond to the
width of the fitting on the flange. Accessory
tools that cannot be fitted precisely onto the
power tool will rotate unevenly, vibrate severely
and can lead to a loss of control.
g) Never use damaged accessory tools. Before
each use, check accessory tools such as
grinding discs for chips or cracks, grinding
plates for cracks, scuffs or excessive wear
and tear. If the power tool or the accessory
tool in use is dropped, check to see if it is
damaged or use an undamaged accessory
tool. When you have checked and inserted
the accessory tool, ensure that you and any
other people in the vicinity remain outside of
the range of the rotating accessory tool and
allow the tool to rotate at maximum speed for
one minute. Damaged accessory tools usually
break during this test period.
■ 66 │ GB │ MT
h) Wear personal protective equipment.
Depending on the application, ensure that
you use full face protection, eye protection or
safety goggles. If appropriate, use a dust
mask, ear protectors, protective gloves or
special apron to protect you from grindings
and material particles. The eyes should be
protected from flying debris that may be caused
during certain applications. Dust or filter masks
must be used to filter any dust produced by the
application. Long-term exposure to loud noise
can cause hearing loss.
i) Ensure that any bystanders are at a safe dis-
tance from your work area. Anyone who
enters the workspace must wear personal
protective equipment.
Fragments of the workpiece or broken acces-
sory tools can fly off and cause injury – even
outside of the immediate working area.
j) Hold the power tool only by its insulated
gripping surfaces when you are performing
work during which the power tool may hit
hidden power lines or its own power cord.
Contact with a live cable may also cause metal
parts of the tool to become live and could result
in an electric shock.
k) Keep the power cable away from any rotating
accessories. If you lose control of the appliance,
the cord may get caught or cut and your hand
or arm could get caught in the rotating accessory
tool.
l) Never put the power tool down until the
accessory tool has come to a complete stand-
still. The rotating accessory tool could come
into contact with the surface and cause you to
lose control of the power tool.
m) Do not leave the power tool running whilst
carrying it. Accidental contact between your
clothing and the rotating accessory tool could
lead to an injury (for example, a cut or puncture
wound).
n) Clean the ventilation slits of your power tool
regularly. The motor fan draws dust into the
housing, and a heavy accumulation of metal
dust can cause electrical hazards.
PWSAP 40-Li A1