Troubleshooting; Optional Accessories; Exploded Drawing And Spare Parts List - Mafell PF80 Originalbetriebsanleitung

7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
please contact your dealer or the MAFELL customer service directly.
Defect
Machine cannot be switched on
Machine switches off
automatically during idling or
stops during the milling process
Milling cutter jams as the machine
is advanced
Burn marks on the milled
surfaces
Chip ejection blocked
Power failure
8

Optional accessories

- Reversible scoring knives for milling head
9

Exploded drawing and spare parts list

The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage or mains
voltage too low
Mains fuse defective
Carbon brushes worn
Mains failure
Blunt milling cutter
Milling cutter that is unsuitable
for the operating sequence or
blunt
Wood is too damp
Extended
extraction
Restart protection
milling without
-20-
Elimination
Have power supply checked by
an electrician
Have fuse replaced by an
electrician
Take the machine to a MAFELL
customer service shop
Have mains-side pre-fuses
checked by an electrician
Switch off the
immediately.
Remove the machine from the
workpiece and replace the milling
cutter
Replace the indexable cutting
inserts
Replace the indexable cutting
inserts
Replace the milling cutter
Dry the wood
Connect machine to an external
extraction system
Switch machine off and on again
Order No. 034907
machine