Safety Devices; Use According To Intended Purpose; Residual Risks; Safety Instructions - Mafell PF80 Originalbetriebsanleitung

2.6 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- Large base plate
- Handles
- Index mechanisms
- Hose connector
- Protective screen
- Protective ring
- Electronic system with restart protection

2.7 Use according to intended purpose

The face milling cutter PF 80 is only suitable for face
milling of material projections over flat surfaces made
of solid wood or wood-like materials.
For this, the base plate of the machine must rest on the
flat areas of the workpiece. Hand-guided processing is
not permitted. (Risk of backlash)
Only use the tool included in the delivery.
Do not remove any safety devices to enable work other
than that described above.
Any other use than described above is not permissible.
The manufacturer cannot be held liable for any
damage arising from such other use.
So as to use the machine as intended, comply with the
operating, maintenance and repair instructions
specified by Mafell.

2.8 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use that can lead
to health consequences will always
remain.
- Machine backlash.
- Touching the milling cutter below the protective
screen.
- Putting down the machine while the tool is coasting
to a standstill and a resulting unexpected movement
of the machine or of an entrained object.
- Breakage and hurling out of the tool or parts of the
tool.
- Hearing impairment when working for long periods
without ear protectors.
- Emission of hazardous wood dusts when operating
the machine for longer periods of time without
extraction.
3

Safety instructions

General instructions:
- Never work without the protection devices stipulated
for the respective operating sequence and do not
effect any modifications on the machine that could
impair safety.
- Children and adolescents must not operate this
machine. This rule does not apply to young persons
receiving training and being supervised by an
expert.
- When operating the machine outdoors, use of an
earth-leakage circuit-breaker is recommended. Use
in wet conditions or in rain is prohibited.
- Secure the workpiece against shifting and always
operate the machine with both hands.
- Do not put down the machine before the tool has
coasted to a standstill.
- Damaged cables or plugs must be immediately
replaced. Replacement may only be carried out by
MAFELL or an authorised MAFELL service
workshop in order to avoid safety hazards.
- Avoid sharp bends in the cable. Especially when
transporting and storing the machine, do not wind
the cable around the machine.
-16-
Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!