Storage; Troubleshooting; Optional Accessories; Exploded Drawing And Spare Parts List - Mafell KF 1000 Originalbetriebsanleitung

6.1 Storage

If the power tool is not used for a longer period of time, it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
please contact your dealer or the MAFELL customer service directly.
Defect
Machine cannot be switched on
Machine stops while working
8

Optional accessories

- Collet Ø 6 mm OZ8 + union nut
- Collet Ø 8 mm OZ8 + union nut
- Face-milling cutter ø 19 mm
9

Exploded drawing and spare parts list

The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Overload
-21-
Elimination
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
Reduce feed speed
Use sharp tool
Order No. 093826
Order No. 093825
Order No. 090282