Technical Data; Emissions; Scope Of Supply - Mafell PF80 Originalbetriebsanleitung

2.3 Technical data

Universal motor
Input power
Idling speed
Hose connector diameter
Cutter diameter
Weight without mains cable
Dimensions (W x L x H)

2.4 Emissions

The declared noise emission values have been measured in accordance with DIN EN 62841-1 and may be used
for comparing the tool with another and also in a preliminary assessment of exposure.
2.4.1 Noise emission specifications
Noise emission values determined according to DIN EN ISO 3744:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
The noise measurement was done without tool at idling speed.
2.4.2 Vibration specifications
The typical hand-arm vibration is less than 2.5 m/s

2.5 Scope of supply

Face milling cutter PF80 complete with:
1 milling head
1 hose connector
1 connecting cable
2 operating tools
1 carrying case
1 operating manual
1 folder "Safety instructions"
Danger
The noise emissions during actual use of the power tool can differ from the declared
values depending on the ways in which the tool is used especially what kind of
workpiece is processed.
Always wear hearing protection, even when the power tool ist running idle in addition
to the trigger time!
L = 71 dB (A)
PA
K = 3 dB (A)
PA
L = 82 dB (A)
PA
K = 3 dB (A)
PA
.
2
-15-
230 V~, 50 Hz
1050 W
4,200 - 10,000 min
-1
35 mm (1.37 inches)
80 mm (3.14 inches)
3.1 kg
160 x 350 x 155 mm (6.29 x
13.77 x 6.10 inches)