Technical Data; Emissions; Scope Of Supply - Mafell KF 1000 Originalbetriebsanleitung

2.3 Technical data

Universal motor, radio and TV
interference suppressed
Power input (nominal load)
Current at nominal load
Idling speed
Tool holding fixture with collet ø
Tool shank maximum
Tool shank minimum
Milling cutter Ø, maximum
Weight without mains cable
Length of connecting cable
Dimensions (W x L x H)

2.4 Emissions

The declared noise emission values have been measured in accordance with DIN EN 62841-1 and may be used
for comparing the tool with another and also in a preliminary assessment of exposure.
2.4.1 Noise emission specifications
Noise emission values determined according to EN 62841:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
The noise measurement was done without tool at idling speed.

2.5 Scope of supply

Edge cutter KF1000 complete with:
1 milling table, complete
1 face-milling cutter ø 19 mm
1 collet Ø 8 mm
1 open-ended spanner AF 17
1 operating manual
1 folder "Safety Instructions"
Danger
The noise emissions during actual use of the power tool can differ from the declared
values depending on the ways in which the tool is used especially what kind of
workpiece is processed.
Always wear hearing protection, even when the power tool ist running idle in addition
to the trigger time!
230 V~, 50 Hz
1000 W
4.6 A
4,000 - 25,000 rpm
8 mm (0 5/16 in.)
8 mm (0 5/16 in.)
3 mm (0 1/8 in.)
30 mm (1 3/16)
2.1 kg (4.63 lbs)
4 m (13 1/8 ft.)
103 x 226 x 328 mm (4 1/16 x 8 57/64 x
12 29/32)
L = 71 dB (A)
PA
K = 3 dB (A)
PA
L = 82 dB (A)
PA
K = 3 dB (A)
PA
-16-