Radioddity GA-5E Bedienungsanleitung Seite 23

Channel Mode (MR): Used for selec�ng preprogrammed channels.
Ex 1. Programming a Channel Repeater Offset with CTCSS Tone
EXAMPLE New memory in Channel 10:
RX = 432.55000 MHz
TX = 437.55000 MHz (This is a (+ 5) Offset)
TX CTCSS tone 123.0
a. Press the [EXIT] bu�on to switch between menus.
b. Press and hold the [MENU] key to set the radio to VFO mode, and the VFO icon is displayed on the right.
c. [MENU][2][9][MENU] [1] [0] [MENU] [EXIT]
d. [MENU] [1][3] [MENU] 123.0 [MENU] [EXIT]
e. Enter RX frequency (Ex. 43255000)
f. [MENU] [2][8] [MENU] [1][0] [MENU]
-->>[EXIT]
g. Enter TX frequency (Ex. 43755000)
h. [MENU] [2][8] [MENU] [1][0] [MENU]
-->> [EXIT]
i. Press and hold the [MENU] key to return to the MR mode and the channel number will reappear.
Ex 2. Programming a Simplex Channel with CTCSS tone
EXAMPLE New memory in Channel 10:
RX = 432.6625 MHz
TX CTCSS tone 123.0
a. Press the [EXIT] bu�on to switch between menus.
b. Press and hold the [MENU] key to set the radio to VFO mode, and the VFO icon is displayed on the right.
c. [MENU] [2][9][MENU] [1] [0] [MENU] [EXIT]
d. [MENU] [1][3] [MENU] 123.0 [MENU] [EXIT]
-->>Use [EXIT] to select Upper display
Deletes Prior Data in channel (Ex. 10)
Selects desired TX encode tone
Enter the desired channel (Ex 10)
RX has been added
Enter the same channel (Ex 10)
TX has been added
Deletes Prior Data in channel (Ex. 10)
Select desired TX encode tone (Ex 123 CTCSS)
20