Installation Of Accessories; Installing/ Removing The Antenna; Installing The Belt Clip; Installing The Ba�Ery Pack - Radioddity GA-5E Bedienungsanleitung

Note:
• It is recommended to power OFF your radio while charging. However, if power is turned on while charging, you may not be
able to transmit a message if the ba�ery is completely empty. Allow �me for the ba�ery to charge to 1 bar before
a�emp�ng to transmit a message.
• For op�mal ba�ery life, remove the radio from the charger within 6 hours. Do not store the radio while connected to the
charger.

3. INSTALLATION OF ACCESSORIES

Before the radio is ready for use we need to a�ach the ba�ery pack, as well as charge the ba�ery.

3.1 Installing/ Removing the Antenna

a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by holding the antenna at its
base and turning it clockwise un�l secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.

3.2 Installing the belt clip

a. At the back of the radio there are two parallel screws mounted above the ba�ery, remove these and thread them through
the holes on the belt clip as you screw them back into the radio body.
b. Removing the Belt Clip: Unscrew counter-clockwise to remove the belt clip.
3.3 Installing the ba�ery pack
Before a�aching or removing the ba�ery make sure your radio is turned off by turning the power/volume knob all the way
counter-clockwise.
a. Make sure the ba�ery is aligned in parallel with the radio body with the lower edge of the ba�ery about 1-2cm below the
edge of the radio.
b. Once aligned with the guide-rails, slide the ba�ery upward un�l you hear a click as the ba�ery locks in place.
Remove the ba�ery pack
8