Basic Operations; Power On The Radio; Turning The Unit Off; Adjus�Ng The Volume - Radioddity GA-5E Bedienungsanleitung

5. BASIC OPERATIONS

5.1 Power on the radio

Turning the unit on
•
To turn the unit on, simply rotate the volume/power knob clockwise un�l you hear a "click". If your radio powers on
correctly there should be an audible double beep a�er about one second and the display will show a message or flash the
LCD depending on se�ngs for about one second. Then it will display a frequency or channel. If the Voice prompt is enabled,
the voice will announce "frequency mode" or "channel mode".
Turning the unit off
•
Turn the volume/power knob counter-clock wise all the way un�l you hear a "click". The unit is now off.
5.2 Adjus�ng the volume
To turn up the volume, turn the volume/power knob clock-wise. To turn the volume down, turn the volume/power knob
counter-clock-wise. Be careful not to turn it too far, as you may inadvertently turn your radio off.

5.3 Making a call

NOTE: Press the [EXIT] key to switch the main channel to the other channel if there are 2 channels shown on the display.
In standby mode, press and hold the [MENU] key to switch between frequency (VFO) mode and channel (MR) mode.
• Channel mode call: A�er selec�ng a channel, hold down the [PTT] key to ini�ate a call to the current channel. Speak into
the microphone with normal tone. Ini�ate a call, the red LED is on.
• Frequency mode call: The off state, hold press [MENU] key to open the radio, switching to the frequency mode, the
frequency range allowed entering, press the [PTT] key, a call to the current channel. Speak into the microphone with
normal tone. Ini�ate a call, the red LED is on.
• Receive a call: When you release the [PTT] key, you can answer it without any ac�on.
15