Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Ensure supply of a sufficient volume of combustion air.
• Check the correctness of chimney installation and/or compliance with the manufac-
turer's requirements; trust the installation and disassembly of the chimney only to
qualified specialists.
3. INSTALLATION MANUAL
3.1. Before commencing installation of the heater
IMPORTANT! Make sure that all safety distances around the heater are observed. There
shall be no electrical appliances, cables, meltable and flammable materials within the
safety distances. Consider the safety distances from the chimney during installation!
• The heater shall be installed in compliance with all local rules, including those referring to
European and national standards.
• The chimney stack for the heater shall be individual, not joint combined for several appli-
ances.
• For more information about fire safety requirements, please, address the local fire depart-
ment.
• Check the availability of all the heater component parts. Make sure that all the heater
bolted connections are tightened.
3.1.1. Configuration of sauna ventilation
1) Self-ventilation (Figure 1):
Air inlet (A) shall be located close to the floor next to the heater. Air inlet is necessary for
fresh air supply to the sauna.
Exhaust outlet (B) shall be located under the ceiling as far as possible from the heater. The
primary purpose of exhaust outlet is to remove moisture from the sauna after steam bathing.
2) Mechanical exhaust ventilation (Figure 2):
Air inlet (A) shall be located at the height of about 500 mm over the stone heater.
Exhaust outlet (B) shall be located as close as possible to the floor, for example, under a bench.
B
B
B
�
�
А ɸ50-100
А
А
50-100
50-100
Естественная вентиляция
Естественная вентиляция
Figure 1.
Self-ventilation
B
B
53
Werbung
Inhaltsverzeichnis
