Heater Commissioning - Grill’D Violet-Serie Installationsanleitung Und Gebrauchsanleitung

Firebox as well as other critical elements of the heater, is made of rolled steel of the required
thickness that can withstand any estimated loads. High-alloyed corrosion-resistant steel is
used for the above heater elements in Pro models.
The effective design for heating up the stones and the steam room is due to numerous bends,
heat-conducting structural elements, which increase the heat dissipation area. Also, air con-
vection between the heater firebox and radiators plays a significant role.
Heater models of Long version are equipped with extended heating flue that allows the heater
to be fired from the adjacent room. Some of the Grill'D heater models of Long version are
equipped with a telescopic heating flue, which allows adjusting the length of the flue depend-
ing on the wall thickness.
Note: dimensions of heaters with a telescopic heating flue are shown in Table 1 and Appendix
1 as a range of values.
All heater models can be optionally equipped with special reinforcing devices (refer to Appen-
dix 4) made of heat resistant high-alloyed corrosion-resistant steel, that enhance combustion
and additionally protect the heater firebox from destruction due to exposure to high tem-
perature. The devices have ducts for supplying additional combustion air, and when it enters
the firebox, the air passes partially above the fire into its upper part, where post-combustion
of flue gases occurs. Additional heat is generated during this process, thus enhancing the
heater's efficiency. There is a grate at the bottom of the heater (refer to Appendix 4). Ash falls
through the sheets of the grate into the ash drawer, which allows convenient cleaning of the
heater without interruption of burning. The grate is one of the most thermally loaded parts of
the heater, it is fabricated of high duty rolled steel with a thickness of 5 mm.
The heater firebox door is fabricated of steel and thermal glass The door opening angle is suf-
ficient for convenient loading of fuel and allows visual monitoring of the burning process due
to the availability of the glass.
The outer surface of the heater is covered with anti-corrosion heat- resistant enamel.
IMPORTANT! Unauthorized modification of the heater is prohibited. The manufacturer
reserves the right to make modifications to the design of the heater that do not impair its
consumer properties.
Violet series
Removable lid allows accessing to the inner compartment of the stone heater and also
serves as a steam restricting device. Water is supplied to the inner compartment of the
stone heater through funnels.
The heater allows obtaining several steam modes:
Fine steam mode is a mode for special ultralight steam obtained by feeding water through
the funnels to the inner compartment of the stone heater, the stones in which are heated
to temperatures above 400 °С. Given the stone heater lid is installed contiguously and the
pressure is growing, the steam escapes through a nozzle located on the lid imitating
the singing of blizzard.
Traditional steam mode is achieved when water is poured onto the outer stone heater.

2.3. Heater commissioning

It is recommended to carry out a preparatory stoking of the heater prior to operation. Com-
pound for metal protection and volatile components of the heat-resistant enamel evaporate
as a result of heating up.
IMPORTANT! Stoking to be carried out outdoors, away from combustible surfaces and
materials, in compliance with fire safety measures and safe work practices.
47