Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT! It is prohibited to use solution of salt to generate steam during operation:
pouring it into the closed stone heater (if available), pouring it onto outer stone heater
and the heater metal.
2.8. Maintenance
Routine maintenance of the chimney, heater and its parts is the key to their efficient
and safe operation, your safety and safety of your close ones!
IMPORTANT! Carry out maintenance works on the heater and chimney only after their
complete cooldown.
IMPORTANT! Take measures recommended for safety. Use personal protective equipment
required for such works.
The heater and chimney shall be cleaned of soot before the commencement of the heating
season, as well as during the entire heating season at least once every three months. Clean-
ing to be performed mechanically. Use special devices, tools and machines (brush, cleaner,
scraper, sinker, vacuum cleaner, etc.). The selection of the necessary tools is made based
on the needs of the cleaning works. Cleaning the flue channels of the heater is carried out
through the cleanout hole after removing the cap (refer to Appendix 2): unscrew both nuts,
remove the cap. After cleaning the flue channels, install the cap, pre-clean the old sealant
and apply a new layer, twin and tighten the nuts.
Soot in the chimney accumulated due to poor cleaning, as well as incomplete combustion
of fuel, can break into flames.
Procedure in case of fire in the chimney:
1. Close the door, the ash drawer, and the flue damper (if available).
2. Call the local fire department.
3. Do not attempt to extinguish the fire with water.
4. After an ignition of soot, a specialist shall check the heater and the chimney for the pos-
sibility of further operation.
IMPORTANT! The use of cleaning log (briquettes), homemade compounds creating high
temperature in the heater firebox and chimney, is prohibited for the purposes of burning
the soot deposited in them.
The stones deteriorate with time as the heater is operated, this is why it is necessary to
turn them over and reposition in the stone heater at least once a year, when the heater is
frequently operated. Remove the destroyed stones and their parts from the stone heater,
replace them with new ones. Before laying the stones, clean the heater with a wet cloth.
The ash drawer shall be cleaned at all times before heating, so that the combustion air pass-
ing through the ash drawer to cool the grate, thereby increasing its service life. If there is a
thermal glass door, use soft cleaning waste with special agents for cleaning heat-resistant
glass of fireplaces and heaters in accordance with the application instructions. Please, obey
fire safety rules!
2.9. Typical faults and troubleshooting methods
1) Fault: Odors appear during the heater operation.
Possible cause:
• There is leftover industrial oil on the heater surface, or/and the odor comes from heat-
resistant enamel.
• When heating up, the heater can enhance the odors present in the air, even if their
source is not the sauna itself or the sauna heater. Such sources, for example, can be
surfaces treated with paint, oil, glue and other materials.
51
Werbung
Inhaltsverzeichnis
