Stones For Stone Heater; Heater Operation - Grill’D Violet-Serie Installationsanleitung Und Gebrauchsanleitung

Vegetation residues (grass, leaves, etc.).
‒
IMPORTANT! The following is prohibited to be used as fuel:
combustible materials with a high heat of combustion (coal, wood chipboard, plastic,
‒
pellets and so on);
painted or impregnated wood;
‒
waste (plastic, rubber, textiles, leather, etc.).
‒

2.5. Stones for stone heater

The permissible stone sizes are given in Table 1.
Only the stones intended for sauna shall be used as heater stones. Use the stone included
into the contents of delivery.
IMPORTANT! Put the stones into the heater only after its complete cooldown.
• Clean the stones from dirt and dust before putting into the heater, thoroughly rinse
them with water.
• Evenly fill in the heater lamellae, avoid blocking and formation of considerable voids.
• For filling in the outer stone heater, please also use the stones included into the con-
tents of delivery.
• Fill in the inner compartment of the stone heater with stones up to no more than 70%
of the volume.
• Do not cover or shut off the nozzle located on the lid of the inner compartment of the
stone heater, while laying stones into it.
IMPORTANT! It is prohibited to use halite to fill stone heaters.

2.6. Heater operation

IMPORTANT! Before each heating up of the heater, make sure that there are no foreign
objects in the firebox, ash drawer or in the chimney, and that there is chimney draft.
1. Remove all unnecessary and foreign objects from the firebox and chimney, remove ash
from the ash box.
2. Put 3-4 logs on the grate in such a way as to ensure free access of air to the combustion
area, namely: lay the firewood loosely, adjust the ash drawer gap to be within 50 mm
3. Ignite the fi ewood loaded into the firebox. The preferred ignition method is using
birch bark, wood chips and other natural materials, or using paper or throwaway news-
papers.
4. Close the door.
5. Partly close the ash drawer after heating up of the chimney and development of stable
draft (usually after burning of the first load of firewood, approximately in 30-45 min-
utes), leaving a gap within 10 mm. It is necessary to constantly ensure sufficient draft,
while avoiding the development of excessive one (it can manifest itself as humming of
the heater, too erratic flame), that leads to heating of the firebox red hot, which signifi-
cantly reduces the heater service life. Control the draft by adjusting the ash drawer gap.
6. Close the ash drawer completely after the air in the bath house heats up to a tempera-
ture of 60-70 С.
0
7. As a rule, 1-2 logs are enough to maintain the temperature in the steam room. In case
the temperature decreases, open the ash drawer and adjust the gap within 3-10 mm in
order to kindle the firewood (it takes more time, when the ash drawer is closed), and
49