Maintenance; Changing The Filter; Ordering Replacement Parts - Silvercrest SLR 30 B1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SLR 30 B1

9.2 Maintenance

9.2.1 Changing the filter

The filter (8) has a service life of approx. 2,000 hours of operation. The service life varies based on the
operating environment. The change filter button
end of its service life. Change the filter (8) promptly when this happens to restore the air purifier to
perfect working order.
DANGER! Risk of electric shock!
Disconnect the air purifier from the mains before each filter change.
To change the filter, proceed as follows:
Switch off the air purifier and remove the plug from the socket.
•
Turn the air purifier upside down to access the cover (9).
•
Turn the cover (9) approx. two centimetres clockwise in the direction of the open lock (see
•
illustration) and remove the cover (9).
Remove the used filter (8) by pulling it out of the air purifier's device housing (6).
•
Insert a new filter (8).
•
Replace the cover (9) noting the recesses on the edge of the cover opening. Lock the cover (9) into
•
place by turning it approx. two centimetres anticlockwise in the direction of the locked lock (see
illustration).
Hold the filter change button
•
A beep will sound and the filter change button

9.2.2 Ordering replacement parts

The filter (8) is subject to wear and is not covered by the guarantee.
You can order a new filter (8) online from the following website:
shop.targa.de
30 – English
(3) will blink as soon as the filter (8) has reached the
(3) for three seconds to confirm the filter change and reset the timer.
(3) will blink three times before turning off.