Duration Of Use; Requirements For The Installation Location - DENIOS. SpillGuard connect Kurzanleitung

1.5. Duration of use

The contractual run time for the wireless
modem and thus the duration of use of
SpillGuard connect® is 5 years. The battery
service life has also been designed for this
period, with the conditions of use expected
being taken into account. If the conditions of
use deviate from these e.g. insuffi cient signal
cover or too low application temperatures,
this will have a negative impact on the service
life of the batter and thus the duration of use
of SpillGuard® connect. SpillGuard® connect
must be replaced following one-off leakage
detection and thus contamination with the
hazardous substance.
Notice:
This does not apply in the event of a false
alarm, which will not have a negative impact
on the function of SpillGuard® connect.
The service life of SpillGuard® connect is a
maximum of 5 years, after which SpillGuard®
connect must be replaced.
i
The SpillGuard® connect battery must not
be replaced!
2. Requirements for the
installation location
SpillGuard® connect is mainly to be used in
the base of a spill sump.
The following prerequisites must be met:
The base of the spill sump must be free of
W
any type of contamination.
SpillGuard® connect must be aligned
W
parallel to the substrate.
The installation location should be at the
W
lowest point of the spill sump so that a
leak is detected as early as possible.
The environment for the installation
W
location should be chosen in such a way
that there is no shielding of or
interference with the wireless signals.
SpillGuard® connect Quick Guide | 276016 | Rev. 2
19/48