DENIOS. SpillGuard connect Kurzanleitung Seite 24

4.3 Alarm procedure
After detecting a leak the following alarms
are given:
5 beeps, 15 s pause
Fast fl ashing during the pause
LED
SpillGuard® connect transmits the
specifi ed text message to the
recipient address saved
the status (alarm) on the web interface
W
is updated
the alarm text saved is sent by text
W
message/e-mail to the recipient
addresses saved (see chapter 3.4).
Press the Push button (>1s and <10s)
1.
1 beep
The alarm is turned off .
24/48
i
When handling hazardous substances,
observe the safety instructions in
the safety data sheet for the leaked
hazardous substance.
Carry out measures to clean up the leak.
1.
WARNING
• Hazard from direct contact with the
hazardous substance
• Injury possible to hands, eyes etc.
• Wear personal protective equipment (PPE)
Press the Push button (>1s and <10s) to
1.
turn off the alarm.
Clean the sensor surface with a soft,
2.
lint-free cloth. In this case, SpillGuard®
connect can be used again.
Switch on and calibrate SpillGuard®
3.
connect (see chapter 4.1 and 4.2).