Adjustable Bottle Shelf; Drawers; Removing The Drawer - V-ZUG Cooler V600 Bedienungsanleitung

Fig. 14
u Push the divisible shelves underneath as in the illustra‐
tion.
Fig. 15
Adjusting the height:
u Pull the shelves out Fig. 15 (1) to the front one by one.
u Pull the support rails out of the catch mechanism and
engage them in place at the desired height.
u Insert the shelves one after the other.
w Flat pull-out stops at the front, right behind the support
rail.
w High pull-out stops at the back.
Using both shelves:
u Hold the bottom shelf with one hand and pull it to the
front.
w The shelf Fig. 15 (1) with the trim strip is at the front.
w The stops Fig. 15 (3) point downward.
Appliances with freezer compartment:
u Do not place shelf rails and divisible shelves in front of
the fan.

7.5 Adjustable bottle shelf

7.5.1 Using the bottle shelf
In the bottom of the fridge section you can either use the
variable bottle shelf or the glass panel.
Fig. 16
u Remove the glass panel and store in a safe place.
u Lay bottles with their base towards the rear wall.
Note
If the bottles are protruding over the front of the bottle
shelf:
u Move the lower door rack up a place.
7.5.2 Removing the bottle shelf
You can remove the bottle shelf for cleaning.
* Depending on model and options
u Remove the glass panel above the bottle shelf.
Fig. 17
u Lift the bottle shelf at the front and pull out.
Note
V-ZUG recommends:
Do not place any goods on the compartment lid below.
7.5.3 Inserting the bottle shelf
Fig. 18
u Slide in the bottle shelf until it engages and push down.

7.6 Drawers

The drawers can be removed for cleaning.
The way to remove/insert the drawers varies depending on
the pull-out system. Your appliance can contain a variety of
pull-out systems.
Note
Insufficient ventilation results in an increase in energy
consumption and reduction of the refrigeration perform‐
ance.
u Leave the bottom drawer in the appliance.
u Never obstruct the vents on the interior rear wall!
Note
The energy consumption increases and the cooling power
goes down if ventilation is not sufficient.
u Always leave the fan air vents clear on the back wall!

7.6.1 Removing the drawer

Drawer on glide rails
Fig. 19
Features
73