Operation; Before Use; Grounding Instructions - Husqvarna W 70 Bedienungsanweisung

• Steel tube
• Floor Nozzle
• Crevice tool
• 1 bag for slurry collection
If 1 of the parts is missing, speak to your local service
agent .
Introduction
WARNING:
product, carefully read and understand
the safety chapter and the operation
instructions.

Before use

WARNING:
a power outlet with the correct voltage, see
the type plate.

Grounding instructions

WARNING:
grounded. If it should malfunction or
breakdown, grounding provides a path
of least resistance for electric current to
reduce the risk of electric shock. The
product is equipped with a cord having
an equipment-grounding conductor and
grounding plug. The plug must be inserted
into an appropriate outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
To connect the correct evacuation hose
The adapter fit most 25 mm/ 1 inch hoses.
• Use the attached adapter.
• Fit the adapter on the hose end.
• Attach the adapter to the outlet.
To attach the suction hose
There is a hose intake with a hose lock on the product.
The hose lock makes sure that the suction hose adapter
do not fall off.
1. Lift the hose lock and attach the suction hose
adapter.
2. Lower the hose lock into the recess of the adapter.
To attach the nozzle on the hand pipe
The floor nozzle has adjustable wheels. Adjust the
wheels to get the best suction effect. Adjust the wheels
1056 - 006 - 09.01.2023

Operation

Before you operate the
Connect the power plug to
The product must be
Make sure to dispose the package and the used product
components in correct procedure. Refer to local disposal
regulations. Make sure to recycle.
with the knob, which is on the rear side of the nozzle.
The wheels and rubber strips of the nozzle can be
replaced. Keep the nozzle in good condition.
To start and stop the W 70
• Push the button (1) to start the product.
• Push the button (0) to stop the product.
MOTOR
0
1
A
To start and stop the W 70 P and the W
250 P
The motor switch is the button A and the pump switch is
the button B referring to the figure.
• Push the button (1) to start the product.
• Push the button (0) to stop the product.
MOTOR PUMP
0 0
1 1
A B
After use
1. Switch off the suction apparatus with the switch.
2. Disconnect the power cord. Do not remove the pump
cable.
3. Empty and clean the suction apparatus and the
accessories used. Refer to
hose on page 7 and To clean the product on page
9 .
MOTOR
0
1
A
MOTOR PUMP
0 0
1 1
A B
To attach the suction
7