Maintenance; Maintenance Schedule - Husqvarna W 70 Bedienungsanweisung

To change the bag
1. Disconnect the power cord and remove the pump
cable.
2. Loosen the 3 toggle fasteners and remove the top.
3. Lift out the float.
Introduction
WARNING:
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
machine. Prevent accidents by being alert
and by planning and preparing the work.
WARNING:
maintenance of the product, make sure that
the motor switch and the pump switch are in

Maintenance

Look for signs of wear,
damage or loose con-
nections of the controls
before the unit is con-
nected.
Empty and clean the
tank and the accesso-
ries.
Do a check of the fil-
1
ters.
Do a check of the
wheels. Look for dam-
age and bad connec-
tions. Castor wheel
locks should be working
in order.
Do a check of the func-
tion of the one-way
valve on P-variants.
1
Only applicable on W 70 and W 70 P.
8
Maintenance
Most accidents involving
Before you do
Before each After every
use use
X
X
4. Remove and dispose the old bag. Refer to local
regulations.
5. Insert the new bag into the stainless steel strainer.
6. Thread the small opening over the internal inlet pipe.
Let the tab rest over the container rim.
7. Do step 1-3 in reversed order.
the Off positions. Disconnect the power cord
and remove the pump cable.
WARNING:
electric components should only be
performed by a licensed electrician.
WARNING:
Risk of dust dispersion.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Daily Weekly
X
X
X
All checks that involve
Do not puncture the filter.
6 months or 12 months or
1000h 2000h
1056 - 006 - 09.01.2023