HEATING
• When the radiator is heating, the
the LCD display, is constantly displayed. As the radiator
regulates, the
may not always be displayed due to the
required heating demand.
ADVANCED MODE
To gain access to all operating modes, please refer
to section 4.0, and set parameter number 01 to
"YES".
STAND ALONE RADIATOR
COMFORT MODE
This mode is to be used during periods of normal
occupancy.
• Default value: 19.0°C
REDUCED MODE
(Advanced mode only)
This mode is to be used at night-time or when the
house is unoccupied for a few hours or more.
• Default value: 15.5°C
PROGRAM MODE
NOTE: By default, the product will follow the commands of an
external programmer when set in this mode.
Program D1 must be selected (default).
To enable the product to follow the internal clock, please refer
to section 4.0, setting parameter number 10 to "YES" to set the
time, and selecting a heating program in parameter number 11.
When you return to the main screen, the selected program and
time settings will now be displayed.
To select a heating program, please refer to section 4.0,
, in section 14 of
and select parameter number 11 to view the available
heating programs.
• Default value: 19.0°C
NOTE: If connected to a gateway, it is not possible to set the time.
ANTI-FREEZE MODE
This mode is to be used when the house is unoccupied for
extended periods of time.
• Default value: 7.0°C
STANDBY MODE
In this mode the radiator is switched off and the word "OFF"
will be shown on the LCD display.
• The radiator will no longer receive signals from a wired
external programmer.
• At any time you can check the measured room
temperature by pressing the "OK" button.
• ATTENTION: Please be aware, if there is no heating in your
property then your pipes could freeze. For the protection of
product and property in very low temperatures we
recommend the "Anti-Freeze" mode is used.
• ATTENTION: In this mode the radiators are still connected to
the electrical supply.
GB
GENERAL
INFORMATION
(Advanced mode only)
(Advanced mode only)
65