Purmo YALI DIGITAL PLUS Installations- Und Bedienungsanleitung Seite 64

GB
GENERAL
INFORMATION
3. OPERATION
•The On/Off button is located at the bottom of the control
side of the radiator (C, picture 5). The radiator should only be
switched "on" when it is correctly installed and secured to
the wall brackets (picture 3E). When the radiator is switched
"on", the LCD screen will illuminate and all segments will be
displayed for a few seconds, then disappear, before
displaying the software version. The "Comfort" or previously
selected operating mode screen will appear. The backlight
will switch off after a further 5 seconds.
• Display (A, picture 5)
18
17
16
15
14
13
12
11
Program information bar or "behaviour" indicator.
1.
Day of week indicator.
2.
Cloud icon (with Unisenza+ Gateway).
3.
"RF connection" indicator (with Unisenza+ Gateway).
4.
Adaptive Start indicator.
5.
"Room temperature" indicator.
6.
Operating mode menu.
7.
8. "Open Window" function indicator.
9. Master/Follower indicator (with Unisenza+ Gateway).
10. Warning indicator.
Installation parameter indicator.
11.
Parameters number when icon "11" is displayed.
12.
Front panel temperature limit indicator.
13.
Heating demand indicator.
14.
Pilot wire indicator.
15.
Display zone for temperatures or time.
16.
Hand icon.
17.
"Key lock" function indicator.
18.
• Keypad (B, Picture 5)
 Right navigation key
 Left navigation key
+ Plus key
– Minus key
OK Validation key
64
GENERAL
HOW TO CHANGE BETWEEN THE OPERATING MODES
In basic mode, only Comfort and Program mode are available.
- Press any button to turn on the backlight.
- Press the "" or "" buttons to enable scrolling
between modes.
1
• Use the left
2
desired operating mode and press "OK" to confirm
3
your choice.
4
5
HOW TO CHANGE COMFORT AND PROGRAM MODE
6
TEMPERATURES
• Press any button to turn on the backlight.
7
• By pressing the "+" or "–" buttons, the set
temperature will start to blink and can be adjusted to
8 the desired temperature level.
• Wait 6 seconds until the new set temperature stops
9
blinking or press the "OK" button to confirm
10
immediately.
NOTE: The comfort temperature setting must always be
higher than the reduced temperature setting. If it is not
possible to lower the comfort temperature to the desired
value, first set the reduced temperature to an even lower
value, or, if it is not possible to increase the reduced
temperature to the desired value (maximum 19 °C), first
increase the comfort temperature.
HOW TO VIEW THE MEASURED ROOM TEMPERATURE
• Press the "OK" button twice. On the first press, the screen
will illuminate, and on the second press, the measured
room temperature will be displayed together with the
room temperature icon
display.
• The display will return automatically to the active
operation mode after 8 seconds.
"" or right "" buttons to move to the
, in section 6 of the LCD