Control Surface Centering; Control Direction Test - Horizon Hobby E-flite Carbon-Z T-28 2.0m Bedienungsanleitung

EN

Control Surface Centering

After assembly and transmitter setup, confirm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the control
surfaces by adjusting the linkages.
After binding a transmitter to the aircraft receiver, set the trims and sub-trims to 0,
then adjust the linkages to center the control surfaces.

Control Direction Test

Switch on the transmitter and connect the battery. Use the transmitter to operate
the aileron, elevator, rudder and flap controls. View the aircraft from the rear when
checking the control directions.
Elevator
1. Pull the elevator stick back. The elevators should move up, which will cause
the aircraft to pitch up.
2. Push the elevator stick forward. The elevators should move down, which will
cause the aircraft to pitch down.
Ailerons
1. Move the aileron stick to the left. The left aileron should move up and the right
aileron down, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and the
left aileron down, which will cause the aircraft to bank right.
Rudder
1. Move the rudder stick to the left. The rudder should move to the left, which will
cause the aircraft to yaw left.
2. Move the rudder stick to the right. The rudder should move to the right, which
will cause the aircraft to yaw right.
Flaps
1. Move your flap control switch down to the partial position.
2. Confirm that the wing flaps move down.
3. Move flap control switch to the full flap position.
4. Confirm the flaps move farther down than in step two.
12
Transmitter command
Carbon-Z
Control Surface Response
T-28 2.0m
®