Trigger - Surveillance Systems AVN314 (ONVIF) Benutzerhandbuch

4.8.5 Trigger

You can set the motion or face detection and select the notification function.
Note: Motion detection is not supported when the stream format is Motion JPEG.
Note: Face detection is not supported when the stream format is set to Multi-Mode.
Trigger Setting
In this section, you can select to enable or disable motion & face detection.
Item
Motion
Trigger Duration
Notification Setting
In this section, you can select to enable E-mail / FTP / SMS notification when a motion
event happens.
Item
Method
Trigger Duration
Record Time
Description
Select to enable or disable the motion detection function.
‧ Motion Detection Area Setting
When "Enable" is selected, click "Detection" to enter the motion detection area setting page as follows:
Level of Sensitivity:
Set the detection sensitivity from 0 ~ 9.
Area Setting:
Set the motion detection area by selecting the area grids with your mouse. Pink grids represent the area that is not
being detected while the transparent grids are the area under detection. You can set multiple areas under detection.
Click "Clear All" to set the whole area undetected.
Click "Select All" to set the whole area under detection.
Set the duration time for trigger recording (5 / 10 / 20 / 40 seconds).
Description
‧Email
When this option is checked, the network camera will upload the captured video clip to the assigned
e-mail address(s) once motion recording happened.
‧FTP
When this option is checked, the network camera will upload the captured video clip to the specified
FTP site once motion recording happened.
‧SMS
When this option is checked, the network camera will send a text message to the specified mobile
phone number once a motion or face detection event occurs. For details, please refer to "4.6.6 SMS"
at page 19.
Set the duration when a motion or face detection event occurs (5 / 10 / 20 / 40 seconds).
Set the record time of the notification video clip (1 ~ 5 seconds).
28