Firmware Upgrade; E-Map - Surveillance Systems AVN314 (ONVIF) Benutzerhandbuch

3.4.3 Firmware upgrade

This function is used when users need to upgrade the network camera for function scalability.
Note: Before using this function, make sure you have the correct upgrade files provided by your installer
or distributor.
Step1: Click " ", and select the IP address of your network camera in the address book.
Step2: Click "
Step3: Click "Add" to browse to the upgrade files.
Step4: Click "Upgrade Firmware" to start firmware upgrade.
Note: It takes a few minutes to finish the upgrade process. Do not disconnect the power during firmware
upgrade, or the upgrade may be failed. The camera will reboot after the upgrade.
Step5: Select the IP address of the camera and click "

3.4.4 E-Map

Video Viewer is also a Central Management System (CMS) software, which allows network device control &
management for up to 16 devices simultaneously.
Note: Before using this function, make sure Video Viewer is connected to all the devices (up to 16) you
want to monitor.
E-Map is ONLY available when the control panel is switch to the full function version.
How to add an E-Map group
STEP1: In the simplified version, click "
to enter the E-Map page as follows.
Note: To know where the buttons are, please refer to "3.3.1 Simplified version (Default) at page 5, and
"3.3.2 Full function version" at page 6.
" to show the upgrade page, "Update Server".
" to switch the control panel to the full function version, and click "
" again to check if the firmware is upgraded.
8
"