Camera; Preset - Surveillance Systems AVN314 (ONVIF) Benutzerhandbuch

4.7 Camera

4.7.1 Camera
Adjust the camera parameters if necessary.
Item
Title
Snapshot Path
Environment
Frame Rate
System Type
Stream Format
ADSL Upload Speed
OSD
Slow Shutter Level

4.7.2 Preset

Note: Before using this function, make sure the DPTZ function is enabled.
You can set new preset points (up to 16) or check existing points here.
How to set a new preset point
Step1: Click DPTZ icon.
Step2: Click to where you want to see, and you'll get a 5x zoom-in image. To slightly zoom out,
draw a square from the bottom right to top left, and you'll get a 3x image. Draw the
square again and you'll return to the original size.
Step3: In "Current Position", give a name to this point, and click "Add".
Description
Enter the title for the camera with up to 15 alphabetic characters.
Specify the location to save the snapshot pictures.
Select the current environment for the camera to automatically adjust itself to produce the
images suitable for the selected environment.
The frame rate allowed to each viewer can be adjusted to adapt to the bandwidth on the
network.
Set the desired image frequency to the maximum (FULL) or to a specified frame rate (1/2; 1/3;
1/4; 1/5; 1/10; 1/15).
The actual frame rate depends on the actual network connection, and may be lower than the
specified one.
It shows the current system type: NTSC or PAL.
Select the stream format to Single H.264 / Single MPEG-4 / Single Motion JPEG / Multi-Mode.
Note:
1. Motion detection is not supported when the stream format is set to Motion JPEG.
2.
Face tracking is not supported when the stream format is set to Multi-Mode.
Select your Internet upload speed, and the system will automatically adjust your data flow.
The options are: Local (>2Mbps) / 2M (2000Kbps) / 1M (1000Kbps) / 640Kbps / 512 Kbps /
256Kbps / 128 Kbps / 64Kbps
Select "ON" to show the camera title on the live view, or "OFF" to hide the camera title.
This function is used to extend the exposure time for clearer images when the light is not
sufficient.
Select 1 ~ 3 to extend the exposure time based on your current light condition. The larger the
value, the longer the exposure time, and the less the fps.
0 means function off.
21