Digital Smart Zoom; Face Tracking - Surveillance Systems AVN314 (ONVIF) Benutzerhandbuch

To schedule the white LED to be enabled, go to "LED Timer Configuration", select "Yes" in
"Enable", and set the time to enable the LED. Each square equals 30 minutes.

4.7.7 Digital Smart Zoom

Column
Smart Zoom
Detection
Sensitivity
Stand-by Interval

4.7.8 Face Tracking

Configure the parameters for face tracking.
Note: Face tracking is not supported when the stream format is set to Multi-Mode, and
will not be shown in the configuration page.
Function
Face Tracking
OSD
Sensitivity
Resolution
Description
To switch this function on or off, select "Enable" or "Disable".
Or, it's also available to click
Select to set a specific detection area for this function.
Select the digital smart zoom sensitivity (HIGH / MEDIUM / LOW)
Select the stand-by interval (Short / Normal / Long).
Description
Select "Enable" to activate or "Disable" to deactivate this function.
Select "ON" to display the following status messages on the live view:
FACE STANDBY: This function is activated and ready to use.
FACE TRACKING: This function is detecting.
FACE ZOOM IN / OUT: This function is zooming on the face for tracking / zooming out when the
tracking object leaves the surveillance area.
Set the tracking sensitivity from HIGH / MEDIUM / LOW.
Set the resolution for face tracking from Auto / VGA / QVGA.
25
to enable / disable this function on the live view panel.