Error Code And Troubleshooting - Abilica HT Treadmill 6.0 Bedienungsanleitung

Feilkoder/Error codes and Troubleshooting
Error Code Fault Description
E01
between controller
E02
E03
E05 Overload protection
Computer doesn't
— —
detect safety key
No display on
computer
1. Check if computer is connected to controller with correct
Failure
communication
2. Change controller and test
and computer 3. Change computer and test
1. Check power voltage is under 50% of normal
Rush Protection
2. Check if motor cords are connected properly.
3. Check if controller has burning smell, if there is change
1. Speed sensor did not detect any speed for 10 seconds.
2. Check the speed sensor cords are connected properly
Speed Sensor
3. Check the speed sensor is properly installed onto the
Malfunction
4. Change a new speed sensor if everything is correct
5. Change a new controller if all of above does not work.
1. Protection is activated when current is overloaded, or
2. Check if there's un-normal smell. If so, please change
3. Check if electric voltage works in proper range
Check if there's un-normal smell. If so, change controller
1. Check if safety key switch works, connecting wire works,
2. Safety key is not placed correctly
3. Safety key is damaged
signal
1. Check if power cable is connected to machine or change
No power
2. Check cable connection between computer and controller
3. Replace adaptor or computer
wires, check connector, check if wire is damaged, or
unplug and re-connect
voltage.
controller.
motor
when
motor cannot run properly. If it's the second situation,
examine the treadmill and re-start it.
motor or
Controller.
or magnet inside works.
to another power outlet. If power switch is in position, test
it by switch ON/OFF. If the power switch is burned out,
replace one and make sure there's power to machine
Solutions