Abilica HT Treadmill 6.0 Bedienungsanleitung Seite 48

It is important to keep your treadmill and surroundings clean to avoid problems and
achieve a minimum of service needs. Therefore, to ensure trouble-free operation, the
following maintenance plan is recommended:
Before use:
• Make sure that the treadmill has no loose parts and that there is no damage to
components before using it.
• Make sure that the surface of the running plate has lubricant applied. Insert
your hand under the running belt, first loosen it if necessary, feel the surface of
the running plate if there is any residue from lubricant. If it is completely dry,
apply lubricant. Always follow the manufacturer's recommended lubrication
interval.
After use:
• Clean, wipe away sweat and remove any particles on running bands and the
surrounding area with a damp cloth.
• Check tightening and centering of running bands.
Every month:
• Wipe away or vacuum dust and dirt that has accumulated around and on the
underside of the treadmill.
• Remove the lid over the engine compartment, remove or vacuum dust that has
accumulated in the engine compartment and on the engine to avoid failure of
electronic components.
• Wipe the running plate to remove dust and dirt with kitchen paper or a cloth
filler. At the same time, consider whether the running plate needs lubricant.
• Check that all bolts, nuts and screws are correctly tightened if necessary.
Every 3 years month:
• Check the condition of the running plate, place a hand under the running belt to
know if the surface of the running plate is smooth and smooth. If there are
irregularities or cracks, the running plate should be replaced or alternatively
reversed if possible on the model.
• Lubricate any air absorbers with teflon-based spray.
Lubrication instruction
Loosen both rear roller bolts to loosen the
running belt, then lubricate the entire top
surface of the running track with the
lubricant. After putting on the lubricant and
again tightening the running belt, insert the
plug and safety wrench, start the treadmill
and walk on the tape for two minutes to
spread the lubricant beyond the running
plate.
48