Installation; Installing/Replacing The Lamp; Danger To Life - EuroLite TS-8 Bedienungsanleitung

(9) Power supply
(10) Fuseholder
(11) DIP-switches
(12) Control LED
(13) DMX-Out socket
(14) DMX-In socket

INSTALLATION

Installing/Replacing the lamp

The lamp must only be changed when wearing appropriate protective clothing (protection glasses, protection
gloves, helmet with sight, leather apron).
The lamp life given by the manufacturer must never be exceeded. This is why you need to take notes on the
operational time of the lamp or check the operating hour meter (if available) regularly and replace the lamp in
time.
Keep exchanged lamp in a protective container and remove accordingly.
During the operation, the lamp reaches temperatures of up to 600° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
9 10
Typ/Type/Type/Tipo: EUROLITE TS-8
Spannungsversorgung/Power supply/Aliment.: 230 V AC, 50 Hz ~
Ges. anschl. wert/Power cons./Puiss. de rendement/Cons.: 285 W
Sicherung/Fuse/Fusible/Fusible: F 2 A, 250 V
Lampe/Lamp/Lampe/Lámpara: ELC 24 V/250 W
F
0.5 m
T =45° C T =65° C
a B
®
eurolite eurolite
www.eurolite.de
MADE IN CHINA
LIGHTING CONTROL
PROTOCOL DMX-512
Vor Gebrauch Anleitung lesen. Lire le mode d'emploi avant l'utilisation. Lea el manual del usuario antes de la puesta en marcha.
Read user manual before use. Only for professional use! Keep away from moisture! Never operate the device without protective shield!
Never look directly into the light source (especially meant for epileptics)! Caution: During the operation the housing becomes very hot!
Danger to life! Do not open for 10 minutes after switching off. Isolate luminaire from all poles of the mains supply before opening the
housing or replacing the lamp. Caution - hot lamp. Maintenance and service operations only by authorized dealers. Replace any cracked

DANGER TO LIFE!

Only install the lamp with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
protective shield.
CAUTION!
21/54
XLR occupation:
1: Ground
2: Signal (–)
3: Signal (+)
Out
1
3
2
In
2
3
1
51785815_V_1_0.DOC
11
12
13
14