Using The Remote Control; Setting Main Operating Mode - Bosch CL6001iU W 70 E Bedienungsanleitung Für Den Betreiber

Operation
Pos. Symbol Explanation
1 Operating function: indirect airflow is active (Wind
avoid me).
Operating function: Movement sensor is active
(Human sensor)
Infographic: self-cleaning is active (I clean).
Operating function: fresh air function is active
(Ionizer).
Operating function: sleep mode is active.
Operating function: follow me function is active
(Follow Me); temperature measurement at the
remote control.
Infographic: wireless control function.
Infographic: battery status
2 Operating mode: automatic mode
Operating mode: cooling mode
Operating mode: dehumidification mode
Operating mode: heating mode
Operating mode: fan mode
3 Value display: shows the set temperature, fan speed
or (when timer is activated) the timer setting as
standard.
Infographic: transmission indicator, lights up when
the remote control sends a signal to the indoor unit.
Infographic: energy saving function active.
Infographic: energy saving function active.
Infographic: ON/OFF timer active.
Infographic: noise reduction is active (Silent Mode).
Value display: shows the current fan speed. There are
several output stages (bars) and the AUTO setting for
automatic control.
4 Infographic: automatic vertical swing function is
active (up/down). Alternatively, display of the current
position of the horizontal louver.
Infographic: automatic horizontal swing function is
active (left/right).
Infographic: Turbo cool/Turbo heat is active.
Table 6 Symbols in the display
56
3.3

Using the remote control

The signal range is 8 m. If objects are in the way or certain fluorescent
lamps are used in the same room this can affect transmission of the
signal.
▶ Point the remote control towards the signal receiver window of the
unit and press the desired key.
The unit emits a beep when it receives a signal.
NOTICE
The remote control may be permanently prevented from working
correctly.
▶ Do not expose the remote control to direct sunlight.
▶ Do not leave the remote control near a heating appliance.
▶ Protect the remote control from moisture and impacts.
3.4

Setting main operating mode

Switching on/off the unit
▶ Press the K key to switch the unit on or off:
The unit starts in the set operating mode.
Settings can also be made when the unit is switched off. The unit saves
the settings, and also retains them in the event of a power failure.
After turning off, the unit remains in standby mode. Intelligent on-off
technology enables an automatic energy-saving mode when on standby
mode (1 W standby).
Automatic mode
In automatic mode, the unit automatically switches between heating and
cooling mode to maintain the desired temperature.
▶ Press Mode key repeatedly until
▶ Select the required temperature with the . and / keys.
The fan speed cannot be adjusted in automatic mode.
Cooling mode
▶ Press Mode key repeatedly until
▶ Press the key until the required air speed is reached.
▶ Select the required temperature with the . and / keys.
Fan (Only) mode
▶ Press Mode key repeatedly until
▶ Press the key until the required fan speed is reached. AUTO can
be selected to enable automatic control.
The temperature cannot be adjusted or displayed in fan mode.
Dehumidification mode (Dry Mode) and set humidity (Humidity
control)
Turn on dehumidification mode:
▶ Press Mode key repeatedly until
▶ Set the required temperature with the . and / keys.
The fan speed cannot be adjusted in dehumidification mode.
Climate 6000i – 6721838271 (2022/11)
appears on the display.
appears on the display.
appears on the display.
appears on the display.