Electrical Connection - S&P EDM-80N Bedienungsanleitung

ENGLISH
EDM-80N Axial Extractor Fans
The EDM-8ON extractor fan range is
manufactured to the high standards
of production and quality as laid down
by the international Quality Standard
ISO 9001. All components have been
checked and every one of the fi nal
products will have been individually
tested at the end of the manufacturing
process.
On receipt of the product we recom-
mend that you to check the following:
1. That it is the correct size.
2. That it is the correct model.
3. That the details on tha rating label
are those you require: voltage, fre-
quency...
The installation must be carried out in
accordance with the eiectrlcal stand-
ards in force in your country.
INSTALLATION
IMPORTANT: Before installing and wir-
ing the unit, ensure that the main sup-
ply is disconnected.
Fig. 1
1. Protection grille
2. Fixing screw
3. Connection terminals
4. Outlet with backdraught shutter
5. Cable entry
The EDM-80N is suitable for wall or
ceiling mounting and can elther dis-
charge directly to the outside or vla an
individual or central ducting system
(see Fig. 2).
The unit can be mounted on the wall or
ceiling using the 2 rubber blocks and
the screws provided.
Make a hole In the wall or ceiling of 100
mm dia.
If the unit is to be installed with indi-
vidual ducting, use a standard 100 mm
dia. duct.
Undo the two grille fi xing screws (1).
Ensure that there are no obstructions
to the airfl ow and that the impeller
turns freeiy.
Fix the extractor to tha wall in such a
way that it is not distorted in order to
avoid nolsa generation or problems
with the rotation of the impeller. Intro-
duce the mains cable through the cable
entry (5) and fi x it to the wall so that the
fi xing screw (2) is above.
Connect the electrical wiring as set out
below and then mount the protection
grille (1) and tighten the screw (2).

ELECTRICAL CONNECTION

This appliance is considered
to be suitable for use in coun-
tries having a warm damp
EN
7