Connecting Wires To Terminals - JVC KW-M875DBW Schnellstartanleitung

Ñ

Connecting wires to terminals

Fuse (15A)
Accessory 1
Light Blue/Yellow
(Steering remote control wire)
Blue/White
[1]
(Power control/Antenna control wire)
Brown
(Mute control wire)
Purple/White
(Reverse sensor wire) (2 m)
Pink
(Speed Pulse Input) (2m)
Light Green
(Parking sensor wire) (2 m)
For best safety, be sure to connect
the parking sensor.
[1] [2]: Blue/White wire is provided two wires, [1] and [2]. Blue/White wire total output ([1] + [2]): 12 V = 350 mA
STEERING WHEEL
REMOTE CONT
REMOTE INPUT
P. CONT ANT CONT
MUTE
REVERSE
S SENS
PRK SW
Other cable : Not used.
A: Black (Ground wire)
B: Yellow (Battery wire)
C: Red (Ignition wire)
A B C
If no connections are made, do not let the cable
come out from the tab.
To steering remote
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not supplied)
matched to your car.
Connect either to the power control terminal when
using the optional power amplifier, or to the power
terminal for the booster amplifier of the film-type or
short pole type antenna.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Connect to vehicle's reverse lamp harness when using
the optional rear view camera.
Connect to the vehicle's speed pulse harness.
Do not cut the "S SENS" tag or failure may result.
Connect to the vehicle's parking brake detection switch
harness.
Connection/Installation
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Connector B
English
17