Cleaning And Storage; Troubleshooting - Cleanmaxx 01181 Gebrauchsanleitung

EN
Do not leave the suction function
constantly switched on so that
the batteries last for as long as
possible.
11. Once the MAX marking of the dirty
water tank (13) has been reached,
switch off the device by pressing the
On / Off switch and empty the dirty
water tank (see the "Cleaning and
Storage" chapter).
Then continue cleaning.
Replace the batteries when the power of
the device starts to wane (see the "Insert-
ing / Changing Batteries" chapter).

CLEANING AND STORAGE

Please Note!
■
Empty both water tanks after each use
of the device to prevent deposits in
the water tanks and any damage to
the device resulting from this!
■
Never assemble wet or damp compo-
nents and insert them into the device!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads.
These may damage the surfaces.
1. Detach the cleaning cloth (1) from the
cleaning attachment (4) and wash it in
accordance with the specifications on
the washing label.
2. Empty and rinse out the dirty water
tank (13):
○ Pull out its sealing cap (14) and pour
away all the remaining water.
○ Use the measuring cup (3) to pour
clean water into the dirty water tank
and then pour it away. Repeat this
process if necessary.
3. Open the fresh water tank (12) and
empty it completely.
14
4. Pull the cleaning attachment (4) off
the main unit (2), then rinse it using
clear water.
5. Wipe down the housing if necessary
with a soft, damp cloth and then dry it
with a soft cloth.
6. Allow all parts to dry in the air before
storing away the device. Leave the
water tanks open to prevent mould
from forming.
• Store the device in a dry, clean and
frost-free place that is protected from
direct sunlight and cannot be accessed
by children or animals.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps that are listed,
contact the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device generates no suction.
The batteries are empty.
► Replace the batteries.
Water runs along the surface.
The cleaning attachment (4) is being held
at an angle so that the dirty water cannot
be sucked up.
► Hold the cleaning attachment hori-
zontally.
Too much pressure is being exerted on
the cleaning attachment (4).
► Pull the cleaning attachment slowly
from top to bottom by applying gen-
tle pressure.