Changing The Oven Light - hanseatic 10153.3eETsDpHbX Gebrauchsanleitung

Page EN-18 Cleaning
(12)
3. Remove the upper pane from the
mounts below the hinges and carefully
set it down.
4. Remove the middle pane and carefully
set it down.
5. Please ensure not to lose the small
spacers (12) and (13).
6. Clean all panes with warm, fresh water.
7. Dry the panes thoroughly.
8. Reposition the middle pane in the
mounts at the hinges.
9. Replace the spacers (12) and (13) at the
sides of the middle pane.
10. Reposition the upper pane in the mounts
at the hinges. Make sure that the smooth
side is facing outwards.
11. Put the grid plate back on top of the door
– it only fits in one direction. First insert
it on the left-hand side and then press
down on the right-hand-side until it clicks
into place.
12. Replace the oven door (see „Replac-
ing the oven door on its hinges" on
page EN-17).
(13)

Changing the oven light

You will need a heat-resistant halogen bulb
G9, 230–240 V, 25 W, 300 °C.
WARNING
Risk of electric shock!
Improper replacement of the bulb can re-
sult in fatal electric shock or burn injuries.
■ Before changing the bulb, always dis-
connect the mains plug or switch off
the fuses for the socket to which the
oven is connected.
■ Replace the bulb only when the oven
is no longer hot and there is no risk of
burns.
1. Switch off and/or unscrew the mains fuse.
2. Place a soft cloth in the cooled oven in
the event that the glass cover or bulb
should fall.
3. Unscrew the glass cover anticlockwise
and remove it.
4. Pull the halogen bulb out using a cloth or
paper. Replace the halogen bulb with a
new one.
5. Wash the lamp cover and then wipe it dry.
6. Insert the glass cover back into the open-
ing and screw it back on clockwise.
7. Switch on/screw the fuse back in.