Technical Data; Noise Emission; Contents Of Delivery; Transport And Start Up - Jet JWL-1640EVS Gebrauchsanleitung

R Tool caddy with tools
S Casting stands

4.2 Technical data

Swing over bed
Centre distance
Number of mechanical speeds
Spindle speed range 1
Spindle speed range 2
Spindle nose
Headstock spindle taper
Headstock spindle bore
Spindle index lock
Headstock-Rotation
Tailstock spindle taper
Tailstock bore
Tailstock ram travel
Centre above floor
Overall (LxWxH)
Net weight
Mains
Output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection
Protection class

4.3 Noise emission

Acoustic pressure level (according to EN ISO 11202):
Idling
In operation
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
4.4 Content of delivery
Lathe bed with headstock, tool support and tailstock – A
350mm Tool rest – B
Legs – C
Spur centre – D
Live centre – E
Live centre with cone – F
Live centre pin – G
Knockout rod – H
75mm Faceplate – J (installed on lathe)
Tool rest extension – K
Faceplate wrench – L
Levellers – M
Tool shelf – N
Socket hd. cap screws, 5/16"x1-1/4" – HP1*
8x
418mm
990 & 940mm
2
40-1200 rpm
100-3200 rpm
M33x3.5 DIN 800
MT 2
9.5 mm
36 x 10°
0°, 30°, 60°, 90°,
120°, 180°, 270°
MT 2
9mm
108mm
1130mm
1854 x 508 x 1334 mm
170 kg
1~230V, PE, 50Hz
1.1 kW (1.5 HP) S1
8 A
3x1.5mm²
16A
I
LpA 72.5 dB(A)
LpA 78.4 dB(A)
Lock washers, 5/16" – HP2*
8x
Flat washers, 5/16" – HP3*
8x
Socket hd. cap screws, 3/8"x1-1/4" – HP4
2x
Lock washers, 3/8" – HP5
2x
User manual
Parts list
* included in hardware package JWL1440-HP1

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted to the floor if required.
For packing reasons the machine is not completely
assembled.

5.2 Assembly

If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Attach the leg stand :
At this point the headstock, tailstock and tool rest should be
removed.
Unscrew the stud (N, Fig 3) from each end of bed.
Fig 2