Maintenance; Troubleshooting - XciteRC Runner 250 Bedienungsanleitung

Maintenance · Trouble shooting
A
B

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem
Model flies circles in Hold
mode
Motors won't start
Model doesn't take off
Modell lands in Coming Home
mode far away from the star-
ting position
Model has no stable hover
flight
XciteRC Runner 250
C
D
Solution
GPS signal poor, look for another place and try again
GPS signal poor, fly. 3-5 minutes in normal mode and check the green
GPS-LED. If it is still on check Position Hold once more
Switch SWA not in position 0
Battery voltage low, recharge or exchange battery
Check the assembly of the propellers – rotational direction
GPS signal poor, look for another place and try again
Re-calibrate model (see paragraph Operation, point 7)
EN
31