Manual - Desert Rookie
4. Turn the wheel counterclockwise to steer to the left. Clockwise = right.
5. Use the trimmer to set the neutral position of the servo. Move the knob counterclockwise to trim
to the right (Clockwise for left). Do this until the vehicle goes straight when you leave the steering
wheel in a neutral position.
6. If the direction of travel on the rudder is opposite to the steering wheel, move the steering reverse
button to the other position. Attention: DO NOT move the throttle reverse button until you are
absolutely sure about this function and it is really necessary.
7. Adjust the servo angle by moving the switch. Up for a larger angle and down for a smaller angle.
8. Once you are done, turn off the ESC power, disconnect the battery and store it in a dry, safe place to
cool down before using it again.
Driving tips:
•
Drive the model on a flat surface and always keep an eye on it.
•
Always release the throttle immediately in the event of a collision to avoid further damage.
•
Do not drive your model near people or property.
•
When you stop driving, turn off the model first and secondly the transmitter.
•
Always disconnect the battery if you are not driving at the moment.
•
Always remove the battery after driving and store it outside the model.
20
www.modster.at