Binding Process: Transmitter And Receiver; Start Guide - Modster Desert Rookie Betriebsanleitung

Manual - Desert Rookie

8. Binding process: transmitter and receiver

The remote control should already be bound to the receiver from the factory.
However, you can bind it at any time as described below:
1. Transmitter and receiver-controller unit must be switched off!
2. Switch on the receiver-controller unit.
3. Switch on the transmitter within 5 seconds.
4. The LED on the receiver now flashes for 3-8 seconds.
5. When the LED stops flashing, the binding was successful

9. Start guide

1. Insert 4 AA batteries (not included) into the transmitter and make sure that the polarity is correct.
2. Connect the battery to the controller, an LED will now light up. ATTENTION: The ESC no longer has
a switch, even if you see the opening for it!
3. To drive forward slowly, pull the throttle lever a little. Accelerate by pulling the lever closer. Brake or
reverse by pushing the lever away from you. Release the lever to bring the car to a stop.
www.modster.at
Switch is up = ON
Switch is down = OFF
Steady light = Battery ok
Flashing = Battery low
19