Turntable Installation - exquisit EMW10-020 inox Gebrauchsanweisung

Turntable Installation

Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly
Installation
1. Remove any protective film found on the microwave oven cabinet surface, do not remove
the light white Mica cover that is attached to the oven cavity to protect the magnetron.
o
2. This oven is intended for built-in use only. It is not intended for counter-top use or
for use inside a cupboard.
3. The appliance can be installed in a 60cm wide wall-mounted cupboard(at least 55cm
deep).
4.The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
5.The mains voltage must correspond to the voltage specified on the rating plate.
6.The socket must be installed and connecting cable must only be replaced by a
qualified electrician.If the plug is no longer to accessible following installation,an
all-pole disconnecting device must be present on the installation side with a contact
gap of at lease 3mm.
7.Adapters,multi-way strips and extension leads must not be used. Overloading can
result in a risk of fire.
a. Never place the glass tray upside down. The glass
tray should never be restricted.
b. Both glass tray and turntable ring assembly must
always be used during cooking.
c. All food and containers of food are always placed
on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
8