Resistance Measurement - Parkside PDM 300 C3 Bedienungsanleitung Und Sicherheitshinweise

PARKSIDE PDM 300 C3

7.6 Resistance measurement

CAUTION! Make sure that all circuit components, circuits and parts to
be measured are disconnected and discharged. Otherwise the multimeter
could get damaged.
• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the Ω position.
• Connect the measurement probes [6] to the object to be measured.
• The measured reading is now shown on the display [1]. If the display [1]
shows "OL", the measuring probes [6] make no contact with the resistance
to be measured or the resistance is faulty.
For resistances > 1MΩ, the measurement may take a few seconds. In this
case, wait until the reading has stabilised.
For measurements of lower resistances (200 Ω range), the resistance of
the device's own measurement cables can distort the reading. In order to
avoid this, note down the reading for the measurement with the
measurement probes short-circuited, and subtract this from the actual
measurement reading.
38 - English
OUT INPUT connection [5].