Function Generator; Resistance Measurement - Parkside PDM 300 C2 Bedienungsanleitung Und Sicherheitshinweise

PARKSIDE PDM 300 C2
• Press the SELECT button [8] to switch between direct and alternating current.
The relevant symbol is shown on the display [1].
• Connect the measurement probes [6] in series to the object to be measured.
• The measured reading is now shown on the display [1]. If the measured
reading is negative, a minus sign is shown in front for DC current
measurements.

7.5 Function generator

CAUTION! Make sure that all circuit components, circuits and parts to be
measured are disconnected and discharged. Otherwise the multimeter
could get damaged.
• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the
• Connect the measurement probes [6] to the object to be measured.
The 1 kHz square wave signal is used, among other things, for checking
and repairs on headphones, amplifiers and other electronic devices and
components.

7.6 Resistance measurement

CAUTION! Make sure that all circuit components, circuits and parts to be
measured are disconnected and discharged. Otherwise the multimeter
could get damaged.
• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the Ω position.
• Connect the measurement probes [6] to the object to be measured.
• The measured reading is now shown on the display [1].
34 - English
OUT INPUT connection [5].
position.
OUT INPUT connection [5].